READY SOLAR · WEST VANCOUVER

Solar and storage.
For West Vancouver.

West Vancouver homes can start with battery backup even when rooftop solar is a later phase. Our outdoor SigenStor project here combines a full-home backup design, EV DC charging equipment and a generator inlet, with a load hub beside the existing double meter base. The site shows how equipment placement and future solar planning can be considered together.

Discuss my West Vancouver project

READY SOLAR PROJECT IN WEST VANCOUVER

Battery backup.
Planned for the property.

Our indoor Sigenergy installation in West Vancouver brings the battery and control equipment together in a dedicated equipment area.

It is a separate project from the outdoor battery and bidirectional EV charging installation featured below. Each layout is designed around the home's electrical service, available space and backup requirements.

Explore our Sigenergy projects
Sigenergy backup equipment in West Vancouver
Sigenergy equipment installed by Ready Solar in West Vancouver.

LOCAL READY SOLAR PROJECT

Outdoor Battery Backup and Bidirectional EV Charger in West Vancouver

We recently completed a full-home backup system for a West Vancouver home, with an outdoor Sigenergy battery, bidirectional EV DC charging and a generator inlet. This is a battery-only installation today, with solar planned for the future. The LoadHub sits beside the home's 400A double meter base, and the equipment is kept outside the living space, neatly arranged against the stone exterior. A compatible vehicle and generator provide additional backup paths, alongside the battery.

See the full project
Aerial view of a Ready Solar battery beside a covered stone entry in West Vancouver.
An aerial view of the same West Vancouver project, showing its outdoor placement beside the covered entry.

26 kW Solar + 36 kWh Sigenergy Full Home Backup on a 400A West Vancouver Estate

26 kW all-black LONGi solar on a black standing seam metal roof, 400A home in West Vancouver, by Ready Solar

West Vancouver homes are built to a higher standard, and the solar and battery system on them should be too. On this 400A waterfront estate, the owners wanted full home battery backup for North Shore windstorm outages, and an installation so clean it blends into a premium property. Ready Solar delivered both.

What we installed

  • 26 kW DC solar using all-black LONGi LR8 panels on a black standing seam metal roof
  • S-5! PVKIT clamps that grip the metal seams, so there are no roof penetrations and the roof warranty stays intact
  • 36 kWh of Sigenergy SigenStor battery storage with Sigenergy hybrid inverters
  • Full home backup on a 400A electrical service, so every circuit stays on when the grid goes down, not just a backup sub-panel
  • Arrays designed and production-modelled in Aurora Solar around the shade from tall coastal evergreens

The challenge: a big property and a long run

The batteries and inverters live in a mechanical room inside a separate shed at the front of the property. The main 400A panel is in the basement of the main home. That meant trenching across a large, fully landscaped property and pulling the solar, battery, ground and smart load conductors all the way to the house.

We dug and laid every run in dedicated conduit, marked each trench with buried caution tape before backfill, and restored the landscaping. At the house, the runs climb under the stairs and along the stone foundation on strut-mounted raceways, grouped, strapped and labelled.

Trench for solar, smart load and ground conduit across a West Vancouver property
Organized strut-mounted conduit along a stone foundation wall, West Vancouver solar install

Clean wire management is our team's superpower

Most homeowners never look at the conduit. We assume they will. Where runs are hidden, they are hidden properly. Where they can be seen, they are straight, evenly spaced and laid out so they look intentional. That is the difference between a solar install and a Ready Solar install.

Sigenergy SigenStor 36 kWh batteries and inverters in a mechanical room, full home backup, West Vancouver

The result

A 400A home in West Vancouver that makes its own clean energy, stores it, and keeps every light, appliance and heat pump running through an outage. It also cuts electricity bills under BC Hydro's self-generation rate, and the property still looks exactly the way the owners want it to.

Looking for solar installers in West Vancouver or home battery backup on the North Shore? Our licensed, in-house electricians design and install solar, battery storage (ESS) and full home backup across West Vancouver, from Ambleside and Dundarave to the British Properties and Caulfeild.

BEFORE WE DESIGN

A good plan starts
with the right details.

For a property in West Vancouver, send us recent electricity bills, the roof age, your electrical panel details and what you want the system to achieve. For new construction, architectural and electrical plans help us coordinate the solar design earlier.

We confirm utility service, permit requirements, travel and scheduling for the actual address. A service-area page does not mean we have a branch office in every city, and a Vancouver-specific building incentive is not assumed to apply elsewhere.

LET’S MAKE A PLAN

Let’s plan your
solar installation.

Tell us about your property. We’ll help you understand what makes sense.

Talk about your project